Hot to reset service light on a Seat Arosa
The SEAT owners manual for the Arosa states.
With the ignition switched off, press and hold the trip meter reset button below the speedometer.
Then, switch the ignition on and hold the reset button for atleast 10 sconds.
Dashes will then appear in the display.
The service has been reset.
Reset service light indicator, engine oil life Volkswagen Eos, reset instructions:
1. Insert the key into the ignition but leave the ignition turned off.
2. Press and hold the trip odometer reset button.
3. Turn the ignition to ON.
4. Press and release the MIN clock adjustment button.
5. Release the trip odometer reset button when the oil change light resets.
Reset the service light indicator, engine oil life on Chrysler Voyager, years 2001 , 2002 , 2003 , 2004 , 2005 , 2006 , 2007 , 2008, oil reset instructions for this model as follows:
1.Swith ignition on.
2.Press the menu reset button untill the service interval is displayed.
3.Repeatedly press the Step button untill to set mileage to next service.
4.Press the C/T button untill the display changes.
5.Tap the Step button untill ‘yes’ appears.
6.Press tghe C/T button then switch off ignition
Reset service interval display, insp and oil service for Volvo XC90, 2006, that can be made manually by use button on car dashboard.
Reset service light indicator, engine oil life Volvo XC90, oil reset instructions:
“Resetting the service reminder indicator (SRI), model years 2002-
The service reminder indicator (SRI) informs the driver that it is time for the car to be serviced. The text message is displayed for 120s each time the ignition is switched on.
Proceed as follows to reset the service reminder indicator (SRI):
1.Ignition position I
2. Press and hold in the reset button for the trip odometer
3. Ignition position II. Note! Turn the key to position II within 2 seconds
4. Hold the reset button for the trip meter pressed in until the original value has been reset. Note! For all vehicles from the 2003 model year a general yellow lamp will light when the reset button must be released
5. Release the reset button for the trip odometer within 4 seconds. The instrument gives an audible signal when resetting has succeeded
6. If the trip meter is already reset the reset button should be held in for a minimum of 10 seconds and a maximum of 14 seconds.
Note! If the reset button for the trip odometer is not released within 4 seconds, the service reminder indicator (SRI) is not reset.”
Reset service interval display, insp and oil service for Volvo 850-70, that can be made manually by use button on car dashboard.
Reset service light indicator, engine oil life Volvo 850-70, oil reset instructions:
RESETTING 5000 MILE SERVICE LAMP ON 1994 + 1995 850
NOTE: This function is for the service reminder lamp, be sure you have performed the proper service such as changing the oil before resetting. If the check engine lamp is illuminated when the car is running, you’ll need to have the car looked at by the Volvo dealer for proper diagnosis.
1. Turn on the ignition to the KPII position so the warning lamps on the dash are illuminated. Do not start the car.
2. Open the bonnet of the car and locate Diagnostic test port (A) behind the driver side headlamp.
3. Remove the cover and pull the jumper wire out of the holder in the cover.
4. Insert the jumper into terminal #7, then press button 4 times, wait approximately 5 seconds and the red lamp should glow continuously. You are now in the data reset mode.
5. Press the button 1 time and wait approximately 5 seconds for the lamp to glow again then press the button 5 times. After about 5 seconds the lamp will illuminate again, press the button 1 time and you will see the lamp flash repeatedly for a couple of seconds indicating that the service lamp has been properly reset.
6. If a mistake is made, simply switch the ignition off and back on to reset and start over.
1996 Model (Some of them)
On these models the diagnostic socket is in front of the gear stick. Switch the ignition on. As you look at the speedometer on the dash, beneath it opposite the trip reset button is a rubber plug. Remove the plug and with a thin pointer such as a ball point pen, depress the pin. This will reset the service light.
1999 Model Service Lamp Reset Procedure
1. Press and hold trip odometer reset button
2. Turn ignition key to run position KPII (not the start position)
3. Wait 30 seconds or until service light begins blinking
4. Release Trip Odometer button
5. Turn ignition to off position