Tag Archives: light indicator

Oil service reset Opel / Vauxhall Meriva

Leave a reply

Reset service light indicator, engine oil life Opel / Vauxhall Meriva, year 2010, 2011, 2012 reset instructions:

How to you reset the service light on a Opel / Vauxhall Meriva?

  1. Press in the trip reset milometer button on the cars dash facia and hold it in, do not release.
  2.  With your other hand insert the key into the ignition switch and turn it to the power on position, do not fire-up the ignition/engine.
  3. Keep the trip reset button depressed whilst the power is on. Dash may countdown from 10 to zero and then reset.

Oil reset service light indicator Chevrolet Impala

Leave a reply

How do you reset oil service light Chevrolet Impala. From years: 1999 – 2012.

Reset oil service light Chevrolet Impala. From years: 1999, 2000, 2001, 2002, 2003, 2004, 2005.

The GM Oil Life System calculates when to change your engine oil and filter based on vehicle use. Anytime your oil is changed, reset the system so it can calculate when the next oil change is required. If a situation occurs where you change your oil prior to a CHNAGE ENGINE OIL message being turned on, reset the system.

After changing the engine oil, the system must be reset.

To reset the CHANGE ENGINE OIL message use one of the folloqing procedures.

Reset oil service light Chevrolet Impala, using the radio. From years: 1999, 2000, 2001, 2002, 2003, 2004, 2005.

  • Turn the ignition to ACC or ON, with the radio off.
  • Press and hold the TUNE DISP knob on the radio for at least five seconds until SETTINGS is displayed.
  • Press the SEEK PSCAN up or down arrow to scroll through the main menu.
  • Scroll until OIL LIFE appears on the display.
  • Press the 1 PREV or 2 NEXT buttons to enter the submenu. Reset will be displayed.
  • Press the TUNE DISP knob to reset. A chime will be heard to verify the new setting and DONE will be displayed for one second.
  • Once the indicator has been reset, scroll until EXIT appears on the display.
  • Press the TUNE DISP knob to exit programming. A chime will be heard to verify the exit.
  • Turn the key to OFF.
  • If the CHANGE ENGINE OIL message comes back on when you start your vehicle, the engine oil life system has not reset. Repeat the procedure.

Reset oil service light Chevrolet Impala, using the accelerator pedal. From years: 1999, 2000, 2001, 2002, 2003, 2004, 2005.

  • Turn the ignition to ON, with the engine off.
  • Fully press and release the accelerator pedal slowly three times within five seconds. If the CHANGE ENGINE OIL message flashes, the system is reset.
  • However, if it stays on, it did not reset. Repeat the procedure.
  • Turn the key to OFF.
  • If the CHANGE ENGINE OIL message comes back on when you start your vehicle, the engine oil life system has not reset. Repeat the procedure.

All information is taken from the Chevrolet Impala manual.

How to reset oil service light Chevrolet Impala. From years: 2006, 2007, 2008, 2009, 2010, 2011, 2012.

How to Reset the Engine Oil Life System Chevrolet Impala.

The Engine Oil Life System calculates when to change your engine oil and filter based on vehicle use. Anytime your oil is changed, reset the system so it can calculate when the next oil change is required. If a situation occurs where you
change your oil prior to a CHANGE ENGINE OIL SOON message being turned on, reset the system.

Always reset the engine oil life to 100% after every oil change. It will not reset itself. To reset the Engine Oil Life System for Chevrolet impala, do the following:

  • Display the OIL LIFE REMAINING on the DIC.
  • Press and hold the SET/RESET button on the DIC for more than five seconds. The oil life will change to 100%.
  • If the CHANGE ENGINE OIL SOON message comes back on when you start your vehicle, the Engine Oil Life System has not reset. Repeat the procedure.

All information is taken from the Chevrolet Impala manual.

Oil reset service light indicator Opel Movano

Leave a reply

How to reset service light indicator Opel Movano.

Reset service light indicator Opel Movano. From years: 2007, 2008, 2009, 2010, 2011, 2012.

  1. Turn the Ignition ON (position 2) but do not start the engine.
  2. Within 10 seconds of turning the key, press the accelerator pedal to the floor and hold it down.
  3. While still holding down the accelerator, press and release the brake pedal twice, then press it a 3rd time and hold it down.
  4. Release both pedals within around 10 seconds, the Oil Service warning light should turn off immediately.
  5. Turn Ignition OFF, then within 3 seconds turn it back ON (position 2).
  6. Turn Ignition back OFF to complete.

Each time the ignition is switched on, the remaining distance before the next engine oil and filter change is due may be shown in the display for approx. 5 seconds. Within 1,800 miles (3,000 km) of the next engine oil change being due, the remaining distance and control indicator will be displayed for approx. 30 seconds as a reminder.

Engine oil life monitor Opel Movano
If control indicator Reset service light indicator Opel Movano, car with a wrench indicator illuminates and control indicator Reset service light indicator Opel Movano, wrench indicator flashes continuously in the display, the engine oil has become oxidized.
If the engine oil has become diluted, control indicator Reset service light indicator Opel Movano, car with a wrench indicator will illuminate in conjunction with control indicator Reset service light indicator Opel Movano, check engine light indicator. In either case it is necessary to carry out an engine oil and oil filter change and to reset the engine oil life monitor.

Oil reset service light Citroen C3 second generation

Leave a reply

Reset service light indicator, engine oil life Citroen C3 V, year 2009, 2010, 2011, 2012, 2013, 2014. reset instructions:

How to reset spanner maintenance light on a Citroen C3 II generation.

For 5 seconds after the ignition is switched on, the spanner fl ashes to indicate that the service must be carried out as soon as possible.

Example: the service is overdue by 300 km.

For 5 seconds after the ignition is switched on, the display indicates:

-180 MILES / 300 KM

5 seconds after the ignition is switched on, the distance recorder resumes its normal operation. The spanner remains lit .

12680 MILES / 20300 KM

The distance remaining may be weighted by the time factor, depending on the driver’s driving habits. Therefore, the spanner may also come on if you have exceeded the two year service interval.

Reset service light Citroen C3 second generation procedure below:

The procedure for resetting to zero is as follows:

  • Switch off the ignition.
  • Press and hold the trip distance recorder zero reset button.
  • Switch on the ignition; the distance recorder display begins a countdown.
  • When the display indicates “=0″ , release the button; the spanner disappears.

Following this operation, if you wish to disconnect the battery, lock the vehicle and wait at least fi ve minutes for the zero reset to be taken into account.

Retrieving the service information.

You can access the service information at any time.

Press the trip distance recorder zero reset button.

The service information is displayed for a few seconds, then disappears.

All information how to reset service light is taken from Citroen C3 second generation owners manual.

Oil service light indicator reset an Audi S8 Service Interval

Leave a reply

Reset service light indicator, engine oil life Audi S8, oil reset instructions:

Instructions:

  1. Locate the trip-meter knob in the lower center of the gauge cluster. The knob is black and you use it to reset your mileage on your tip-meter.
  2. Push inward on the knob until the service interval light starts to flash. This generally takes about 10 seconds.
  3. Let the knob out, and then tap it in one time quickly to turn off the light.

You can expect the Audi S8 service interval light to come on every 3,000 miles when it is time to change the oil in your vehicle. You can also expect it to come on every 15,000 miles for a regular maintenance check. If you usually take your Audi to the dealership to have it serviced, they will turn the light off for you. However, if you want to save money and do the work yourself, you need to know how to turn off the service interval light yourself.