Category Archives: Service light reset Fiat

Oil reset, oil light indicator, maintenance light reset, service light reset, without using a computer for Fiat

Reset trip computer Fiat Fiorino

Leave a reply

How to reset trip computer Fiat Fiorino.

Reset trip computer Fiat Fiorino. From year: 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014.

The “Trip computer” is used to display information on vehicle operation when the key is turned to MAR. This function allows to define two separate trips called “ Trip A ” and “ Trip B ” for monitoring the “ complete mission ” of the vehicle ( trip ) in a reciprocally independent manner. Both functions are resettable ( reset – start of new mission ).

“ Trip A ” is used to display data relating to:

  • Range.
  • Trip distance.
  • Average consumption.
  • Instant consumption
  • Average speed
  • Travel time (driving time).

“Trip B” is supplied on versions having a multifunctional display and is used to display data relating to:

  • Trip distance B.
  • Average consumption B.
  • Average speed B.
  • Travel time B (driving time).

Note “ Trip B ” functions may be disabled ( see paragraph “ Trip B on ”). “ Range ” and “ Instant consumption ” cannot be reset.

Values displayed.

Range.

Indicates the travel distance left before the vehicle runs out of the fuel in the tank. The message “—-” will appear on the display in the following cases:

value lower than 50 km (or 30 mi).
vehicle left parked with engine running for long.
IMPORTANT Changes of the range value can be affected by many factors: driving style (see paragraph “Driving style” in section “Starting and driving”), type of route (motorway, urban cycle, mountain roads, etc…), conditions of use of the vehicle (load, tyre pressure, etc…). Trip planning must take into account the above notes.

Trip distance.

Indicates the distance covered from the start of a new mission.

Average consumption.

Represents the approximate average consumption from the start of a new mission.

Instant consumption

Indicates the fuel consumption. The value is constantly updated. The message “—-” will appear on the display if the vehicle is parked with the engine running.

Average speed

Represents the vehicle average speed as a function of the overall time elapsed since the start of a new mission.

Trip time

Indicates the time elapsed since the start of a new mission.

IMPORTANT If information is not available, the message “—-” will appear instead of the Trip Computer values. Counting of the different values will be resumed regularly when normal operation is restored. This will not cause any resetting of the values displayed before the failure nor starting a new mission.

Reset trip computer Fiat Fiorino

TRIP control button fig. 19

Button TRIP located on the top of the right steering column stalk is used (with ignition key at MAR) to display and reset the previously described values to start a new mission:

short pressing to display the different values;
prolonged pressing to reset and then start a new mission.
New mission

The new mission begins after:

“manual” resetting by the user, by pressing the relevant button;
“automatic” resetting, when the “Trip distance” reaches 3999.9 km or 9999.9 km (according to the type of display) or when the “Trip time” reaches 99.59 (99 hours and 59 minutes);
disconnection/reconnection of the battery.
IMPORTANT Value resetting from the screens of “Trip A” makes it possible to exclusively reset the data regarding this function.

IMPORTANT Value resetting from the screens of “Trip B” makes it possible to exclusively reset the data regarding this function.

“Start trip” procedure.

With ignition key on MAR, press and hold button TRIP pressed for over 2 seconds to reset.

Exit Trip.

To exit the Trip function: hold MENU ESC pressed for longer than 2 seconds.

All information how to reset trip computer is taken from Fiat Fiorino owners manual.

That it is the full procedure how to reset trip computer Fiat Fiorino. If you like to reset any maintenance oil light after an oil change. Or reset check engine light, airbag light, inspection key or insp errors when maint reqd, for Toyota cars. Or any warning light for service reminder which appears on the display. Write in the search box the car name for which you want to find information, and find how to reset other service reminders by yourself.

This is an information site where you can solve your car problems. Send us a comment if our procedures are correctly. If you would have anything to add, for us every opinion counts.

Reset service spanner light Fiat Fiorino

Leave a reply

How to reset service spanner indicator Fiat Fiorino.

Reset service spanner light Fiat Fiorino. From year: 2008, 2009, 2010, 2011, 2012, 2013, 2014.

Reset service spanner light Fiat Fiorino

Scheduled Servicing (Service) Fiat Fiorino.

Through this function it is possible to display information connected to proper vehicle servicing.

This information is consulted as follows:

  • briefly press button MENU ESC: service in km or mi, according to previous setting, will be displayed (see paragraph “Units”);
  • briefly press button MENU ESCto go back to the menu screen or press the button for long to go back to the standard screen.

The “Scheduled Service Plan” requires the vehicle to be serviced every 30,000 km (or 18,000 mi). This indication will appear automatically with the key at MARstarting from 2,000 km (or 1240 mi) and will be presented automatically every 200 km (or 124 mi). The indications will appear more frequently when there are 200 km left. The indication will appear in kilometres or miles depending on the unit set. When the next scheduled servicing is approaching, the message “Service” will appear on the display followed by the number of kilometres or miles left when the key is turned to MAR. Go to the Fiat Dealership where the “Scheduled Service Plan” operations will be performed and the message will be reset.

All information how to reset service spanner indicator is taken from Fiat Fiorino owners manual.

Reset oil service light Fiat Ducato 3

Leave a reply

How to reset oil service light Fiat Ducato III.

Reset oil service light Fiat Ducato 3. From year: 2007, 2008, 2009, 2010, 2001, 2012, 2013, 2014.

Engine oil level gauge.

This gauge shows the engine oil level.

Versions with digital display.

Turning the ignition key to MAR, the display will show the engine oil amount by displaying five symbols.

Reset oil service light Fiat Ducato 3

Partial gradual turning off of the symbols indicates oil decrease.

If the oil level falls below the preset limit (topping up is therefore required), the five dashes will start flashing on the display.

The oil level is correct when 4 or 5 symbols are turned on. If the fifth symbol does not turn on, it shall not be considered as a failure or low oil level in the sump.

IMPORTANT Proper engine oil level shall however be checked by means of the dipstick (see paragraph “Checking levels” in section “Vehicle maintenance”).

Few seconds after, engine oil amount symbols will disappear from the display, and:

  • if scheduled servicing interval is near to come, the display will show the distance to cover and the instrument panel warning light Reset key service Fiat Ducato third generation will turn on. When reaching the scheduled servicing interval the display will show some dashes.
  • then, if engine oil change interval is near to come, the display will show on the top of the screen the distance to cover to next oil change together with message “OIL” displayed on the bottom of the screen. When reaching the scheduled servicing interval the display will show five dashes.

Versions with multifunction display.

Turning the ignition key to MARthe display will show the oil level by the turning on/off of five symbols.

Reset oil service light Fiat Ducato 3

Partial gradual turning off of the symbols indicates oil decrease. The oil level is correct when 4 or 5 symbols are turned on. If the fifth symbol does not turn on, it shall not be considered as a failure or low oil level in the sump. When the oil level falls below the preset limit the display will show the dedicated message to warn the driver that topping up is required. IMPORTANT Proper engine oil level shall however be checked by means of the dipstick (see paragraph “Checking levels” in section “Vehicle maintenance”).

Few seconds after, engine oil amount symbols will disappear from the display, and:

if scheduled servicing interval is near to come, the display will show the distance to cover and symbol Reset key service Fiat Ducato third generation. When reaching the scheduled servicing interval the display will show a dedicated message.
then, if engine oil change interval is near to come, the display will show the distance to cover to next oil change. When reaching the scheduled servicing interval the display will show a dedicated message.
All information are taken from Fiat Ducato 3 owners manual.

Fiat Ducato 3 reset air cleaner indicator

Leave a reply

How to reset air cleaner indicator Fiat Ducato III.

Reset air cleaner indicator Fiat Ducato 3. From year: 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014.

Air cleaner replacement shall be carried out at Fiat Dealership.

Air filter – dusty roads (where necessary) Fiat Ducato third generation.

The air filter specific for dusty areas is equipped with a visual blockage signalling device A-fig. 11. It is therefore necessary to periodically check the blockage sensor indicator Please refer to the “Programmed Maintenance Plan” shown in the Chapter “Maintenance and care”.

Reset air cleaner indicator Fiat Ducato 3Reset air cleaner indicator Fiat Ducato 3

Upon reaching the calibration value, the indicator is activated B-fig. 11a and it switches to the red light position, even when the engine is switched off. In order to reset the signalling device, proceed with the cleaning/substitution of the cartridge as with normal equipment and reset the indicator by pressing button C-fig. 11a.

Attention: use a jet of air so as to clean the air filter, do not use water or liquid detergents. Such filter is specific for the versions suitable for dusty areas; therefore it is advisable to seek help from the Fiat Assistance Network for the substitution of the filter.

All information how to reset air cleaner warning light is taken from Fiat Ducato 3 owners manua.

Fiat Ducato 3 reset seat belt reminder light

Leave a reply

How to reset S.B.R. (seat belt reminder) light Fiat Ducato III.

Reset seat belt reminder light Fiat Ducato 3. From year: 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014.

The vehicle is fitted with the S.B.R. system (Seat Belt Reminder), consisting of a buzzer which, together with the turning on flashing of warning light < on the instrument panel, warns the driver to fasten the seat belt.

The buzzer can be deactivated (until the next engine stop) as follows:

  • fasten the driver’s seat belt;
  • turn the ignition key to MAR;
  • wait for over 20 seconds and then release one of the seat belts.

For permanent deactivation, contact Fiat Dealership.

With digital display, the S.B.R. system can only be reset at Fiat Dealership.

With multifunction display, the S.B.R. system can also be reset through the set-up menu.

That it is the full procedure how to reset seat belt reminder light Fiat Ducato 3. If you like to reset any maintenance oil light after an oil change. Or reset check engine light, airbag light, inspection key or insp errors when maint reqd, for Toyota cars. Or any warning light for service reminder which appears on the display. Write in the search box the car name for which you want to find information, and find how to reset other service reminders by yourself.