Tag Archives: reminder

Reset seat belt reminder light Toyota Land Cruiser 100 series

How to reset seat belt reminder lightt Toyota Land Cruiser 100 series.

Reset seat belt reminder lightt Toyota Land Cruiser 100 series. From year: 2002, 2003, 2004, 2005, 2006, 2007.

Driver’s seat belt reminder light and buzzer.

The light and buzzer act as a reminder to buckle up the driver’s seat belt. Once the ignition key is turned to “ON” or “START”, the reminder light flashes and the buzzer sounds if the driver’s seat belt is not fastened. Unless the driver fastens the belt, the light continues flashing and the buzzer sounds 4 to 8 seconds. If the light stay on after you connected the belt you may have a problem with the airbag or with the sensor.

Front passenger’s seat belt reminder light.

The light acts as a reminder to have the front passenger buckle up the seat belt. Once the ignition key is turned to “ON” or “START”, the reminder light flashes if a passenger sits in the front passenger seat and does not fasten the seat belt. Unless the front passenger fastens the belt, the light continues flashing. If luggage or other load is placed on the front passenger seat, depending on its weight and how it is placed on the seat, built−in sensors in the seat cushion may detect the pressure, causing the reminder light to flash.

To reset the seat belt reminder light Toyota Land Cruiser 100 series you must go to a authorized dealer to reset this warning light for you.

All information are taken from Toyota Land Cruiser 100 series owners manual.

Reset front passenger’s seat belt reminder light Toyota FJ Cruiser

How to reset front passenger’s seat belt reminder light Toyota FJ Cruiser.
Reset front passenger’s seat belt reminder light Toyota FJ Cruiser. From year: 2007, 2008, 2009, 2010, 2011.

The light and buzzer act as a reminder to have the front passenger buckle up the seat belt. Once the ignition key is turned to “ON” or “START”, the reminder light flashes if a passenger sits in the front passenger seat and does not fasten the seat belt. If the vehicle speed rises above 20 km/h (12 mph) with the seat belt unfastened, the buzzer will sound for 10 seconds. Then, if the seat belt is still unfastened, the buzzer will sound in a different tone for 20 seconds. Even if the vehicle speed drops below 20 km/h (12 mph), the buzzer will continue to sound. To stop the buzzer, fasten the seat belt. If the buzzer still sounds, make sure the driver’s seat belt is fastened. If luggage or other load is placed on the front passenger seat, depending on its weight, the reminder light may flash and buzzer to sound.

The buzzer can be set not to sound by following the procedure below.

  1. Sit on the front passenger seat.
  2. Turn the ignition key to the “OFF” position with the odometer reading shown. For details see the Odometer and two trip meters om Toyota categories.
  3. Turn the ignition key to the “ON” position.
  4. Within 6 seconds, push the trip meter reset knob and hold it for more than 10 seconds.
  5. Insert the tab of front passenger seat belt into the buckle.
  6. The odometer shows either “b−on” or “b−off”. The reading changes by pushing the trip meter reset knob and the setting of the front passenger seat belt reminder buzzer can be changed. The odometer display returns to normal if the meter reset knob has not been operated for more than 10 seconds or the ignition key is turned to the “OFF” position.

All information how can you reset front passenger’s seat belt reminder light is taken from Toyota FJ Cruiser owners manual.

How to check service reminder light Toyota Solara 2 generation

How to check service reminder light Toyota Solara 2 generation. From year: 2004, 2005, 2006, 2007, 2008.

How can you check service reminder light Toyota Solara second generation.

CHECKING SERVICE REMINDER INDICATORS except the low fuel level warning light and low windshield washer fluid level warning ligh).

  1. Apply the parking brake.
  2. Open one of the doors. The open door warning light should come on.
  3. Close the door. The open door warning light should go off.
  4. Turn the ignition key to “ON”, but do not start the engine. All the service reminder indicators except the open door warning light should come on. The “ABS”, “VSC” and low tire pressure warning lights, engine oil replacement reminder light, “TRAC OFF” and slip indicator lights go off after a few seconds. The SRS warning light goes off after about 6 seconds.

If any service reminder indicator or warning buzzer does not function as described above, have it checked by your Toyota dealer as soon as possible.

All information how to check service reminder light is taken from Toyota Solara 2 generation owners manual.

That it is the full procedure how to check service reminder light Toyota Solara 2 generation Toyota Solara second generation. If you like to reset any maintenance oil light after an oil change. Or reset check engine light, airbag light, inspection key or insp errors when maint reqd, for Toyota cars. Or any warning light for service reminder which appears on the display. Write in the search box the car name for which you want to find information, and find how to reset other service reminders by yourself.

Reset seat belt reminder light Toyota Tacoma second generation

Reset seat belt reminder light Toyota Tacoma second generation. From year: 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014.

How to reset seat belt reminder light Toyota Tacoma 2 generation.

Driver’s seat belt reminder light and buzzer.

The light and buzzer act as a reminder to buckle up the driver’s seat belt. Once the ignition key is turned to “ON” or “START”, the reminder light flashes and buzzer sounds if the driver’s seat belt is not fastened. Unless the driver fastens the belt, the light continues flashing and the buzzer stops after about 4 to 8 seconds.

Front passenger’s seat belt reminder light.

The light acts as a reminder to have the front passenger buckle up the seat belt. Once the ignition key is turned to “ON” or “START”, the reminder light flashes if a passenger sits in the front passenger seat and does not fasten the seat belt. If luggage or other load is placed on the front passenger seat, depending on its weight, the reminder light may flash.

All information how can you reset seat belt reminder light is taken from Toyota Tacoma second generation owners manual.

That it is the full procedure how to reset seat belt reminder light Toyota Tacoma second generation. If you like to reset any maintenance oil light after an oil change. Or reset check engine light, airbag light, inspection key or insp errors when maint reqd, for Toyota cars. Or any warning light for service reminder which appears on the display. Write in the search box the car name for which you want to find information, and find how to reset other service reminders by yourself.

Reset service light, maintance on Toyota Rav 4

This Maintenance light is a reminder : “TIME FOR AN OIL CHANGE!”

1. Turn the ignition key to the ‘OFF’ position with the trip meter A reading shown.

2. Turn the ignition key to the ‘ON’ position while holding down the trip meter ‘RESET’ button.

3. Hold down the knob for at least 5 seconds. The odometer indicates ‘000000’ and the light goes off.