Tag Archives: repeat

Servive light reset oil life indicator dashboard Chevrolet Camaro

How do you reset maintenance light, reset service light indicator Chevrolet Camaro, year 2014, 2015. For reset maintenance light and that can be made manually by use button on car dash board.

Reset service light indicator, engine oil life Chevrolet Camaro, year 2014, 2015 oil reset instructions:

  1. Turn the ignition to run.
    *one position before starting engine
  2. Immediately after Step 1 press and release the gas pedal 3 times within 5 seconds.
  3. If the “Change Engine Oil Soon” message is not on, the system is reset. If it is on, turn the ignition off and repeat steps 1-2.
  4. Turn the ignition off and then start the engine to verify the indicator has been reset.

Oil light reset maintenance Buick LaCrosse

Reset service light indicator, engine oil life Buick LaCrosse, year 2005, 2006-2010, 2011-2013 reset instructions:

2005

1. Turn the ignition to run (one position before starting engine).
2. Immediately after Step 1 press and release the gas pedal 3 times within 5 seconds.
3. If the CHANGE OIL SOON indicator flashes
engine and repeat steps).
4. Turn the ignition off and start the engine to verify the indicator has been reset.

2006-2010

With Driver Information Centre (DIC):
1. Turn the ignition to run (one position before starting engine).
2. Press the OPTION button on the DIC until ENGINE OIL MONITOR appears on the DIC screen.
3. Press the SET/RESET button to reset the system. The next screen indicates that the CHANGE OIL SOON message has been reset. If the vehicle has the up level DIC, when the gauges button is pressed and the OIL LIFE REMAINING mode appears, it should read 100% OIL LIFE REMAINING.
4. Turn the ignition off and start the engine to verify the indicator has been reset.

Without Driver Information Centre:
1. Turn the ignition to run (one position before starting engine).
2. Immediately after Step 1 press and release the gas pedal 3 times within 5 seconds.
3. If the CHANGE OIL SOON indicator flashes, the system is reset (if this does not happen, turn off the
engine and repeat steps).
4. Turn the ignition off and start the engine to verify the indicator has been reset.

2011-2013

1. Turn the ignition to run (one position before starting engine).
2. Press the DIC menu button on the turn signal lever to enter the vehicle information menu. Use the thumbwheel to scroll through the menu items until you reach REMAINING OIL LIFE.
3. Press the SET/CLR button to reset the oil life to 100%.
4. Turn the ignition off and start the engine to verify the indicator has been reset.

SERVICE INDICATOR SYSTEM SEAT CORDOBA

Service indicator system Seat Cordoba, 1993, 1994, 1995, 1996, 1997, 1998, 1999

IN00, No service is required, standard display.

OEL, When 7500 miles has been reached before the yearly service is required.

IN01, Indicates time for the yearly service inc oil change.

IN02, Indicates it is time for the Major service. T

O RESET THE INDIVIDUAL COUNTERS.

1) turn on ignition (do not start).

2) Press the trip reset button button on the speedo (the trip value will not reset to zero but will reappear when the procedure is finished).

3) Turn off the ignition and thne release the trip reset button. In the LCD display you will see the word OEL. Using the minute set button for the clock (lower one) you will reset the OEL interval counter. Press it, hold, release, 5 horizontal lines will appear in the display.

4) press and release the trip reset button. In the LCD display you will see IN01 repeat step 3 to reset the inspection counter when required.

5) Again press the trip reset and rest the IN02 counter if necessary. If doing an oil change only reset the OEL counter. If doing an inspection service reset both the OEL and IN01 counters. If doing a full service reset all 3, OEL, IN01 and ,IN02.

6) Turn on ignition (do not start the car).

7) After the appearance of the IN00 display turn off the ignition.

8) You are done the trip counter should read as it did before you started.

PROGRAMMING THE INTERVALS TO REQUIREMENTS

With todays higher spec oils and/or peoples need and desire to service more regular there is a way to alter the counters to your prefered settings (within reason).

1) Turn on ignition (dont start the car).

2) press the trip reset button also press the Minute set button on the clock (lower one).

3) The LCD display OEL 1,S where the S indicates SET.

4) Using the trip reset button you can call up the following counter data in sequence.

OEL 1,S Distance counter for oil change (7500 standard).

OEL 2,S Time counter for oil change (12 months).

IN 01,S Time counter for yearly service interval (12 months).

IN 02,S Distance counter for full service (15000 miles).

5) Using the minute SET button on the clock (lower one) you can display the current value repeated pressing of the button will select a subsequent lower value and at the lowest level will reset to the highest and start to decrease again (so dont panic). the steps work in miles (500 at a time) and time steps in bi-monthly (1, 2months) i.e.1,2,3,4,5,6.

6) Once you have set the counter to the value you require turn off the ignition.

7) Job done

Reset the service light on a 2002 Rover 75

There are 3 stages
locate the obd plug and find pin 8 then
turn ignition to pos 2
with a fused wire ( a piece of wire with a fuse in it)
ground pin 8 for 4-5 seconds
turn ignition off
repeat this procedure 2 more times but for 8-12 seconds and then the service indicator will be reset.

Oil service reset Bravada

2002-2004

Turn the ignition to run (one position before starting engine).
Immediately after Step 1 press and release the gas pedal 3 times within 5 seconds. If the CHANGE ENG OIL light flashes for 5 seconds, the system is reset. If the light does not flash, repeat the procedure.
Turn the ignition off and then start the engine to verify the indicator has been reset.