How can you reset service light, maintance on Toyota Avensis
1. Set the multi-information display to TRIP A.
2. Turn the ignition switch off.
3. Press and hold the ODO / TRIP switch, and turn the ignition switch on (IG).
4. After turning the ignition switch on (IG), keep holding the switch for at least 5 seconds.
1. Turn the ignition on without starting the engine.
2. Set the display window to ODO, TRIP.
3. Turn the ignition switch off.
4. Pressing the button PUSCH ODO TRIP reset switch turn the ignition switch to the ON position (keep pressing for at least 5 seconds).
5. Reset procedure is complete
Reset service light indicator, engine oil life Fiat Ducato, year 2007, oil reset instructions:
Switch Ign on (do not start engine)
Set Odometer to read total miles.
Press Odometer Button (OB) until CFG1 appears in display
Release the OB.
Pressing the OB briefly will change between CFG1, CFG2, CFG3, CFG1
Once you have selected the CFG (see below).
Press the OB again for 5secs to store the new service frequency.
Turn off the ignition.
I selected CFG1 for my vehicle (05 Reg 2.8JTD), but you must decide yourself for your vehicle, should take 5mins to read this and carry out the resetting procedure
Note: If your vehicle is under warranty and you take it to be serviced by a Fiat dealer they will do this as part of the service.
CFG1 = 30000km (18,600mi) and 365 days in cases of Standard Use for 2.0 petrol and 2.8JTD versions, or in the case of Severe Use for the 2.3JTD versions.
CFG2 = 20000km (12,500mi) and 365 days in case of Standard Use for 2.0JTD versions, or in case of severe use for 2.0 petrol and 2.8JTD versions
CFG3 = 15000km (9,300mi) and 365 days in case of Severe Use for 2.0JTD versions
1986-88
When “CHECK ENGINE OIL” is displayed on the Super Monitor, press the “SELECT” button below the display until “ENGINE OIL” mode is displayed (unless it already is displayed). Then press and hold the “SET” button until “OK” is displayed.
Reset service light indicator, engine oil life Volkswagen Tiguan, year 2009-2010 reset instructions:
Manual Reset:
Turn the ignition to run (one position before starting engine).
Press and HOLD the trip-odometer button “0.0”.
Turn your key to run (one position before starting engine).
Release the trip-odometer button.
Push and release the Clock Minute Set Button “min”.
Turn the ignition off and then start the engine to verify the indicator has been reset.