Tag Archives: key

Reset the Oil Life on My Suzuki XL7

Leave a reply

How do you reset maintenance light, reset service light indicator Suzuki XL7. For reset maintenance light and that can be made manually by use button on car dash board.

Reset service light indicator, engine oil life Suzuki XL7, oil reset instructions:

Instructions

1.Sit in the driver’s seat of the XL7. Insert the ignition key and turn it to “RUN.” Do not start the engine.

2.Press and release the gas pedal three times within five seconds. Watch for the engine oil light to flash, indicating that the system is reset.

3.Turn the key to “OFF” and remove it from the ignition.

Reset service light, maintance on Toyota Rav 4

Leave a reply

This Maintenance light is a reminder : “TIME FOR AN OIL CHANGE!”

1. Turn the ignition key to the ‘OFF’ position with the trip meter A reading shown.

2. Turn the ignition key to the ‘ON’ position while holding down the trip meter ‘RESET’ button.

3. Hold down the knob for at least 5 seconds. The odometer indicates ‘000000’ and the light goes off.

Reset service light oil life indicator dashboard Honda Accord

Leave a reply

Reset service light indicator, engine oil life, dashboard oil life indicator Honda Accord, instructions for manually resetting the trip computer:

1) Turn they key to the II position

2) Turn the key to the off position, and push and hold in the odometer reset button

3) Turn they key back to the II position, while still holding the button.

4) After about 10-15 seconds, the light should go off.

Rover 75 Reset Oil Service Light

Leave a reply

Well after a small but required service on the car I had to reset the warning light. The real quick deal to reset all the requested lights on Rover 75 is to do the following

Get a small wire, Turn the key to second position, Short Pin 8 and Pin 4 on the OBD connector for “4 seconds to reset oil light”, “8-25 seconds for the other 2 lights” and this will reset the 15000 service request for oil change. Quick and easy and not legal if you do it without actually doing the service.

Reset oil change light on a 2008 dodge nitro

Leave a reply

1. Turn the ignition key to ON but do not start the engine.
2. Slowly depress the accelerator to the floor and release it three times within 10 seconds.
3. Turn the ignition key to the OFF position.