Switch ignition OFF
Press and hold button A (underneath rev counter)
Switch ignition ON
Release button A
A spanner symbol will be displayed
Turn button A clockwise
Switch ignition OFF
Vehicles on fixed interval servicing can be reset as follows
Press and hold button “A” (positioned right of trip recorder display)
Switch ignition ON
The word “SERVICE” will appear in the trip recorder display
Release button “A”
Turn button “B” (positioned left of trip recorder display) to the right to reset the display
Switch ignition OFF
This applies to fixed service intervals only appearently
Button “A” is the trip reset
Button “B” is the clock set
Service light reset is as follows:-
1. Press and Hold the Odometer knob in
2. Turn the ignition on (do not start the car though)
3. Turn the odometer knob to the right and hold for about 5 secs.
4. Release odometer knob and switch ignition off.
5. Start car, Service indicator should now be gone.== Answer ==
cheers for the info worked first time probably saved me a few quid putting the car to a dealers.
ta much!
this worked on a 2000 modal with out a problem
Reset service light indicator, engine oil life Volkswagen Crafter 2.5 td, reset instructions:
VW Crafter service reset Sitting in the drivers seat looking at the dash on the left hand side you have a M button and below it a 0 button these are the buttons you will need to use.
When i refer to the LCD this is the illuminated part in the middle that shows your mileage,service mileage and trip mileage.
Please read this fully first to get the jist of it as if you perform the actions too slow it wont work and you will have to start over.
1.Put on ignition
2.Wait for service mileage to revert to vehicle mileage
3.When it reverts to the vehicle mileage press and hold the 0 button until you hear a beep (can take up to 30 seconds)
4.As soon as you hear the beep press the M button repeatdly and you will see in the LCD display different reset’s the one you need to select is “reset 51” if you go past it just keep pressing the M button till it comes up again.
5.When the “reset 51” is displayed stop pressing the M button then press and hold the 0 button again until a number 2 is displayed in the LCD.
6.Release the 0 button and then press twice and it will say in the LCD reset done ,if it is not reset you will get a 30% power reduction after 2K miles