Tag Archives: LCD

Mitsubishi L200 2.5 DiD service indicator reset

How do you reset maintenance light, reset service light indicator Mitsubishi L200 2.5 DiD, year 2006. For reset maintenance light and that can be made manually by use button on car dash board.

Reset service light indicator, engine oil life Mitsubishi L200 2.5 DiD pickups 2006, oil reset instructions:

  1. Close all doors and bonnet.
  2. Switch on ignition.
  3. On the LCD display there are three buttons on the left, navigate, info and set up.
  4. Press and hold the “set up” button for 25-30 seconds.
  5. You will now see “do you wish to reset the service reminder”
  6. Select yes/o.k.
  7. Follow the on screen instructions to exit set up.
  8. Switch ignition off.

Oil reset service light indicator Land Rover Discovery 3

Reset service light indicator Land Rover Discovery 3. How to reset maintenance light, reset oil service light. Can be made manually by use button on car dash board.

Reset service light indicator Land Rover Discovery 3.

Procedure to check/reset service status, distance counter on a Land Rover Discovery 3.

  1. Switch ignition OFF.
  2. Press and Hold left instrument panel reset button, switch ignition ON to position I (accessories).
  3. Keep reset button pressed for approximately 5 seconds until the LCD displays RESET SIA.
  4. The distance to service (e.g. 2150 miles) and the service type (e.g. Inspection/oil service) will be displayed.
  5. Has the Reset Distance limit been reached or exceeded? o NO.
  6. Follow instructions in section 2 below o YES Follow Reset Distance Counter instructions below Reset Distance counter procedure.
  7. Press and hold left instrument reset button for 5 seconds. RESET will begin to flash on the LCD display.
  8. To reset distance the left hand button should be pressed before the RESET message has flashed 5 times. The LCD will display END SIA. Switch ignition off.

Procedure to check/reset service status date counter on a Land Rover Discovery 3.

  1. Press left instrument panel reset button once.
  2. The LCD will display RESET SIA followed by the service due date.
  3. Has the Reset Date limit been reached or exceeded? o NO.
  4. Press the left instrument button once.
  5. The LCD will display END SIA to indicate the service interval check/reset procedure has been cancelled. o YES, Follow Reset Date Counter instructions below Reset Date counter procedure.
  6. Press and hold left instrument reset button for 5 seconds.
  7. RESET will begin to flash on the LCD display.
  8. To reset distance the left hand button should be pressed before the RESET message has flashed 5 times.
  9. The LCD will display END SIA. Switch ignition off.

oil-reset-service-light-indicator-Land-Rover-Discovery-3

Service reset VW Volkswagen Crafter 2.5 td

Reset service light indicator, engine oil life Volkswagen Crafter 2.5 td, reset instructions:

VW Crafter service reset Sitting in the drivers seat looking at the dash on the left hand side you have a M button and below it a 0 button these are the buttons you will need to use.

When i refer to the LCD this is the illuminated part in the middle that shows your mileage,service mileage and trip mileage.

Please read this fully first to get the jist of it as if you perform the actions too slow it wont work and you will have to start over.

1.Put on ignition

2.Wait for service mileage to revert to vehicle mileage

3.When it reverts to the vehicle mileage press and hold the 0 button until you hear a beep (can take up to 30 seconds)

4.As soon as you hear the beep press the M button repeatdly and you will see in the LCD display different reset’s the one you need to select is “reset 51” if you go past it just keep pressing the M button till it comes up again.

5.When the “reset 51” is displayed stop pressing the M button then press and hold the 0 button again until a number 2 is displayed in the LCD.

6.Release the 0 button and then press twice and it will say in the LCD reset done ,if it is not reset you will get a 30% power reduction after 2K miles

Service light reset Mercedes Benz Sprinter 2007

Reset service light indicator, engine oil life Mercedes Benz Sprinter, year: 2007, oil reset instructions:

Sprinter service reset Sitting in the drivers seat looking at the dash on the left hand side you have a M button and below it a 0 button these are the buttons you will need to use.

When i refer to the LCD this is the illuminated part in the middle that shows your mileage,service mileage and trip mileage.

Please read this fully first to get the jist of it as if you perform the actions too slow it wont work and you will have to start over.

1.Put on ignition

2.Wait for service mileage to revert to vehicle mileage

3.When it reverts to the vehicle mileage press and hold the 0 button until you hear a beep (can take up to 30 seconds)

4.As soon as you hear the beep press the M button repeatdly and you will see in the LCD display different reset’s the one you need to select is “reset 51” if you go past it just keep pressing the M button till it comes up again.

5.When the “reset 51” is displayed stop pressing the M button then press and hold the 0 button again until a number 2 is displayed in the LCD.

6.Release the 0 button and then press twice and it will say in the LCD reset done ,if it is not reset you will get a 30% power reduction after 2K miles