2005-2012
1. Turn the ignition to run (one position before starting engine).
2. Select trip metre A reading by using the trip metre button and then turn the ignition off.
3. While pressing the trip meter reset button
4. Continue to press and hold the button until the trip meter displays “”000000″”.”
5. Turn the ignition off and then start the engine to verify the indicator has been reset.
2012
1. Turn the ignition to run (one position before starting engine).
2. Select trip metre A reading by using the trip metre button and then turn the ignition off.
“3. While pressing the trip meter reset button
4. Turn the ignition off and then start the engine to verify the indicator has been reset.
Hot to reset service light on a Seat Arosa
The SEAT owners manual for the Arosa states.
With the ignition switched off, press and hold the trip meter reset button below the speedometer.
Then, switch the ignition on and hold the reset button for atleast 10 sconds.
Dashes will then appear in the display.
The service has been reset.
1. Turn your ignition key to the ‘ACC’ or ‘LOCK’ position.
2. Press and hold the trip meter reset nob (next to your Toyota Land Cruiser’s odometer).
3. While holding the trip meter reset nob, turn the ignition to ‘ON’, but do not start your Toyota Land Cruiser.
4. Hold the meter reset until the MAINT REQD light switches off.
If this procedure does not successfully reset your maintenance required light, make sure that your digital odometer is set with the odometer reading showing and try again. If the light is still lit, you can try disconnecting your Toyota Land Cruiser battery, causing the internal computer to reset. If you still haven’t successfully turned off the oil indicator MAINT REQD light, please read your manual or contact your dealer for further instruction!
This Maintenance light is a reminder : “TIME FOR AN OIL CHANGE!”
1. Turn the ignition key to the ‘OFF’ position with the trip meter A reading shown.
2. Turn the ignition key to the ‘ON’ position while holding down the trip meter ‘RESET’ button.
3. Hold down the knob for at least 5 seconds. The odometer indicates ‘000000’ and the light goes off.