Category Archives: Service light reset Land Rover

Oil reset, oil light indicator, maintenance light reset, service light reset, without using a computer for Land Rover

Oil service reset Land Rover LR2

2006-2010

Press and hold the trip reset button with the vehicle stationary and in a power mode less than 6 (two positions before starting engine).
While holding the trip reset button, enter the vehicle into power mode 6 (one position before starting engine).
Release the trip reset button within 10 seconds of entering power mode If the manual reset mode has been successfully entered ‘dISt’ or ‘DATE’ will be displayed in the odometer, depending on which trigger has been activated.
To clear the ‘dISt’ trigger press, and hold the trip reset button for more than 5 seconds within 10 seconds of entering the manual re-set mode. If successful, ‘RESET’ will be displayed in the odometer for 5 seconds. If the date trigger has not been activated ‘END’ will then be displayed in the odometer.
If the date trigger has been activated, ‘DATE’ will be displayed in the odometer. To clear the trigger press and hold the trip reset button for more than 5 seconds within 10 seconds of ‘DATE’ being displayed. If successful, ‘RESET’ will be displayed within the odometer for 5 seconds followed by ‘END’ The odometer will now exit re-set mode.
Turn the ignition off and then start the engine to verify the indicator has been reset.

Service light reset Land Rover Freelander II 2007

Instructions on how to reset the service interval for engine oil exchange the Land Rover Freelander II, the years 2007,2008, 2009, 2010, following the instructions below.

  1. Insert key in ignition slot.
  2. Press and hold button right.
  3. Press and hold start/stop button to turn on ignition.
  4. Within 10 seconds, release button . The message “DATE” or “dISt” will appear in cluster center screen.
  5. Within 10 seconds, press and hold button right during at least 5 seconds.
  6. The message “RESET” will be displayed for 5 seconds in the screen.
  7. The message “DATE” or “END” will then be displayed.
  8. If the message “DATE” is displayed, within 10 seconds press and hold button right for at least 5 seconds.
  9. The message “RESET” will be displayed for 5 seconds in the screen.
  10. The message “END” will appear in the screen wich indicates the exit of reset mode.
  11. Press start/stop button to switch ignition OFF.