Reset oil service Suzuki Grand Vitara diesel 2013

Leave a reply

How do you reset maintenance light, reset service light indicator Suzuki Grand Vitara. For reset maintenance light and that can be made manually by use button on car dash board.

Remove dash service light Suzuki Grand Vitara 1.9, diesel 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014.

Instructions

  • Ignition on (engine not running)
  • Foot on accelerator all the way down
  • At the same time pump the brake pedal 3 times

This must be done within 10 seconds of turning ignition on.

Reset the auto up feature Fiat 500

Leave a reply

How to reset the auto up feature Fiat 500.

Reset the auto up feature Fiat 500. From year : 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014.

Should the Auto Up feature stop working, the window probably needs to be reset. To reset Auto Up:

  • Pull the window switch up to close the window completely and continue to hold the switch up for an additional two seconds after the window is closed.
  • Push the window switch down firmly to the second detent to open the window completely and continue to hold the switch down for an additional two seconds after the window is fully open.

Wind buffeting Fiat 500.

Wind buffeting can be described as the perception of pressure on the ears or a helicopter-type sound in the ears. Your vehicle may exhibit wind buffeting with the windows down, or the sunroof (if equipped) in certain open or partially open positions. This is a normal occurrence and can be minimized. If the buffeting occurs with the sunroof open, adjust the sunroof opening to minimize the buffeting or open any window.

Reset service spanner light Fiat Ducato

Leave a reply

How to reset service wrench light on a Fiat Ducato second edition.

Reset service spanner light Fiat Ducato. From year : 2002, 2003, 2004, 2005, 2006, 2007.

  • Turn ignition to on without starting the engine.
  • Press and hold the button situated in right side of the dashboard.
  • The button must be held down for about 10 seconds until the display shows a spanner and CFG 1.
  • Release the button and then press it again and hold down for about 5 seconds until the CFG1 and wrench key will disappear.
  • Done, you managed to resetservice spanner light Fiat Ducato 2.

Reset oil maintenance required Toyota Venza

Leave a reply

How do you reset maintenance light, reset service light indicator Toyota Venza, From year: 2008, 2009, 2010, 2011, 2012, 2013. For reset maintenance light and that can be made manually by use button on car dashboard.

Reset service light indicator, engine oil life Toyota Venza, oil reset instructions:

The oil change system should be reset. Perform the following procedures:

  1. Switch the display to the trip meter A when the engine is running. See below picture.
  2. Vehicles with smart key system: turn the “ENGINE START STOP” switch off. Vehicles without smart key system: turn the engine switch to the “LOCK” position.
  3. Vehicles with smart key system: while pressing the trip meter reset button, set the “ENGINE START STOP” switch to IGNITION ON mode but do not start the engine because otherwise the reset mode will be canceled. Continue to press and hold the trip meter reset button until the trip meter displays “000000”.
  4. Vehicles without smart key system: while pressing the trip meter reset button, set the engine switch to “ON” position but do not start the engine because otherwise the reset mode will be canceled. Continue to press and hold the trip meter reset button until the trip meter displays “000000”.
  5. See below picture with trip meter reset button.

All information how to reset engine oil maintenance indicator is taken from Toyota Venza owners manual.

Reset change oil light indicator service Fiat 500

Leave a reply

How do you reset maintenance light, reset service light indicator Fiat 500, from year: 2014, 2015. For reset maintenance light and that can be made manually by use button on car dashboard.

Reset service light indicator, engine oil life Fiat 500, oil reset instructions:

How to reset change oil indicator system Fiat 500.

  1. Turn the ignition to run (one position before starting engine).
  2. Fully depress the accelerator pedal slowly three times within 10 seconds.
  3. Turn the ignition off and then start the engine to verify the indicator has been reset.