2004-2005
Turn the ignition to run (one position before starting engine).
Ensure ODO/TRIP display screen is in the odometer mode. Turn ignition off.
While pressing ODO/TRIP button, turn ignition to run (one position before starting engine).
Continue to hold button for over 5 seconds.
Turn the ignition off and then start the engine to verify the indicator has been reset.
2006-2007
Turn the ignition to run (one position before starting engine).
Ensure odometer reading is shown. Turn ignition off.
While holding down the trip meter reset knob turn the ignition to run (one position before starting engine).
Hold down knob for at least 5 seconds. The odometer indicates “000000” and the light goes off. If the system fails to reset, the light will continue flashing.
Turn the ignition off and then start the engine to verify the indicator has been reset.
2008-2010
Turn the ignition to run (one position before starting engine).
Ensure odometer reading is shown. Turn ignition off.

Vehicles with smart key system:
3.While pressing the trip meter reset button, press the “ENGINE START STOP” switch to IGNITION ON mode. Continue to press and hold the button until the trip meter displays “000000”.
Vehicles without smart key system:
3.While pressing the trip meter reset button, turn the ignition to run (one position before starting engine). Continue to press and hold the button until the trip meter displays “000000”.
4. Turn the ignition off and then start the engine to verify the indicator has been reset.