2012
05.02
Category:
Range Rover /
Tag:
Airbag, battery, battery terminal, cable, cable clamp, clamp, code, control, cycle, electronic control module, Instructions, maintenance light reset, minute, module, oilreset.com, Open, point, range, range rover, reset service light, reset the on-board computer, reset your own service light, service indicator, service insp, service light, service light procedures, service light reset, service light reset without using a computer, service oil, Slide, terminal /
Instructions
1. Open the hood and loosen the retaining nut on the cable clamp running to the negative battery terminal.
2. Slide the clamp off of the negative battery terminal.
3. Wait 1 minute for the Range Rover’s electronic control module to cycle and reset. Then, reconnect the clamp to the negative battery terminal.
4. Tighten the retaining nut on the cable clamp. The airbag light should go out at this point. When it does, you’ll know that the fault code has been erased.
These servicing warning lights are normally reset (turned off) by the main dealer once they have finished servicing your vehicle.
If you have just serviced your vehicle yourself, or had it serviced in a local garage you may find that the 'service interval warning light' still needs to be reset to turned the light off.
2012
05.02
Category:
Rover /
Tag:
car, change, connector, deal, light, maintenance light reset, obd, oil, oilreset.com, pin, position, Quick, request, required service, reset service light, reset the on-board computer, reset your own service light, SERVICE, service indicator, service insp, service light, service light procedures, service light reset, service light reset without using a computer, service oil, service request, Short, Turn, wire /
Well after a small but required service on the car I had to reset the warning light. The real quick deal to reset all the requested lights on Rover 75 is to do the following
Get a small wire, Turn the key to second position, Short Pin 8 and Pin 4 on the OBD connector for “4 seconds to reset oil light”, “8-25 seconds for the other 2 lights” and this will reset the 15000 service request for oil change. Quick and easy and not legal if you do it without actually doing the service.
2012
05.02
Category:
Rover /
Tag:
fuse, ground, ground pin, ignition, indicator, maintenance light reset, obd, oilreset.com, piece, pin, Plug, procedure, repeat, RESET, reset service light, reset the on-board computer, reset your own service light, rover, SERVICE, service indicator, service insp, service light, service light procedures, service light reset, service light reset without using a computer, service oil, wire /
There are 3 stages
locate the obd plug and find pin 8 then
turn ignition to pos 2
with a fused wire ( a piece of wire with a fuse in it)
ground pin 8 for 4-5 seconds
turn ignition off
repeat this procedure 2 more times but for 8-12 seconds and then the service indicator will be reset.
2012
05.02
Category:
Renault /
Tag:
button, car, Clio, counter, display, ignition, indicator, maintenance light reset, oilreset.com, part, Press, renault, reset service light, reset the on-board computer, reset your own service light, SERVICE, service indicator, service insp, service light, service light procedures, service light reset, service light reset without using a computer, service oil, stalk, Switch, toggle, toggle button, toggle switch, Turn /
Turn on the ignition, but don’t start the car. On the right stalk there is a toggle switch that hinges up and down, and is used for going through the different features of the display. When the display shows ‘Service Due’ press and hold the top part of this switch for 10 seconds until the dispaly resets and it shows 30,000km or whatever until next service.
Turn on the ignition, but don’t start the car. On the right stalk there is a toggle switch that hinges up and down, and is used for going through the different features of the display. When the display shows ‘Service Due’ press and hold the top part of this switch for 10 seconds until the dispaly resets and it shows 30,000km or whatever until next service.
all of the above is correct apart from pressing the toggle button. if you instead press the bottom toggle button for 10 seconds the display will start to flash. Keep button depressed and 5 seconds later the service counter will reset.
2012
05.01
Category:
Volvo /
Tag:
button, car, ignition, indicator, maintenance light reset, meter, minimum, model, oilreset.com, position, Press, reminder, reminder indicator, reset button, reset service light, reset the on-board computer, reset your own service light, SERVICE, service indicator, service insp, service light, service light procedures, service light reset, service light reset without using a computer, service oil, signal, time, trip odometer, value, year /
“Resetting the service reminder indicator (SRI), model years 2002-
The service reminder indicator (SRI) informs the driver that it is time for the car to be serviced. The text message is displayed for 120s each time the ignition is switched on.
Proceed as follows to reset the service reminder indicator (SRI):
1.Ignition position I
2. Press and hold in the reset button for the trip odometer
3. Ignition position II. Note! Turn the key to position II within 2 seconds
4. Hold the reset button for the trip meter pressed in until the original value has been reset. Note! For all vehicles from the 2003 model year a general yellow lamp will light when the reset button must be released
5. Release the reset button for the trip odometer within 4 seconds. The instrument gives an audible signal when resetting has succeeded
6. If the trip meter is already reset the reset button should be held in for a minimum of 10 seconds and a maximum of 14 seconds.
Note! If the reset button for the trip odometer is not released within 4 seconds, the service reminder indicator (SRI) is not reset.”
